Shop Discount Sea-Doo Parts

Recent content by JJinSC

  1. JJinSC

    97 xp clunking noise when trying to start

    Am I not seeing a ground in picture#1
  2. JJinSC

    97 xp clunking noise when trying to start

    Standard auto fuel line. You will need about 25 feet total of 1/4" and 5/16" line. I cannot remember how much of each because it has been a while since I did mine, but I think it may have been 10' of 5/16" and 15' of 1/4".
  3. JJinSC

    Fuel selector switch

    If it is 180 off then it is stripped and Jamed or there is a non standard after market valve installed
  4. JJinSC

    Fuel selector switch

    That switch is on, not reserve. You cannot put the knob on incorrectly. It is keyed.
  5. JJinSC

    97 xp clunking noise when trying to start

    Post some pictures.
  6. JJinSC

    97 xp clunking noise when trying to start

    Mostly, the recommendation is to rebuild your existing OEM. The parts are not that expensive. The aftermarkets are expensive because they do not last and you would be constantly replacing them and experiencing failure.
  7. JJinSC

    97 xp clunking noise when trying to start

    1997 Sea-Doo XP, 5662 Starter | Sea-Doo Warehouse
  8. JJinSC

    97 xp clunking noise when trying to start

    If it is not an OEM starter, I personally would dump it and start with a rebuilt OEM starter. You should not be getting Sparks from a starter. That is a very dangerous thing in a bilge. Your beeper may be bad, also. Common issue if it has not been replaced.
  9. JJinSC

    Wear ring question...screws?

    Hmm, mine has plastic pump housing but no screws. I've never seen this brought up before. Learn something new everyday. Lol
  10. JJinSC

    Wear ring question...screws?

    Interesting, what purpose so they serve? It is hard to tell in the picture but it looks like these screws are in the channel for the plastic piece with the syphoning tubes
  11. JJinSC

    Wear ring question...screws?

    Not on any Sea-Doo I have ever seen. Especially the two models you have listed in your profile.
  12. JJinSC

    2000 XP no spark

    Let's get the simple things settled for no spark. Your ski is 19 years old. Have you removed the boots from the spark plugs wires, cut the wires back 1/4" inch and screwed the boots back on?
  13. JJinSC

    DUDE !!!!

    Congratulations!! I love it when a plan comes together. Including someone elses plan [emoji1]
  14. JJinSC

    Gas evaporated?

    Clarification here. While I state I saw it with a full tank, I meant that I have seen gas come out of the inlet vent (not functioning properly) enough to see gas run down the side of the hull due to expansion of gas in a full tank. I did not mean pissing it out and by no means emptying the tank.
  15. JJinSC

    Wont start in water 99 gtx rfi

    Oops, that's right. RFI. Sorry.
Top