Recent content by Jgaddis

Installed new battery and it fired right up.going to take to the lake and try it out.

Go Got my new battery charging it up.

I’m not sure when I brought the ski during the fall was told just needed a start button. If I send a picture can you tell if it’s right.

I did check compression it has 150psi on both cylinders

I just did and it didn’t help. With plugs out I may have spark as long as I’m holding start/stop button and engine is turning but if I let off button and try again it may or may not have spark

I just noticed that sometimes I will have spark then other times I won’t.

Yes I even put a new connector on it

Ok so I tried to start it. I’m getting no spark to plugs. With lanyard unplugged if I hit the start/stop button lights comes on. After plugging in lanyard when I hit the start/stop engine will turn over. (No beeps while lanyard is plugged in)I checked both plugs no spark. I also used a test...

Will see if it will run tomorrow

After going through wiring again I have found a plug that was not making connection. Now light comes on and engine turns over with switch.

Could my MPEM be bad. When I brought ski guy told me all it needed was start/stop button which the old one was stuck you could not push at all. Before I replaced the switch I checked gas and it was very old so I drained tank and took carbs off and cleaned them. So I know it was setting for a...

No when I push start/stop the gauges do nothing.

Yes it is

Please help I brought this sea doo xp800 in the fall was told it needed a start button.it needs more. I have no power to anything. No beeps no click or anything.I have installed new start/stop button. Replaced new post for lanyard, checked fuses. Unplugged all connectors and checked for breaks...