Recent content by Jaiello

I bought pistons rings and crank fully assembled it was 800 plus shipping. I thought it was high but it’s installed now.

Just rebuilt my 2001 xp. I had to do both the bottom end and top end. The piston rod bearing exploded. All the pins where in the bottom of the engine. This caused the piston to catch and bent the piston rod. Pure carnage, I went the road of buying a new crank with all the bearings and piston...

I can post a pic before it went in

You will have everything attached except the carbs and exhaust

Oh before I forget follow the break in procedure or you will be doing this again soon. Also if bored over remember to shave your rave valves and smooth out edges of the cylinder opening with a file so you won’t catch a piston ring. I am sure you will find tons of things I have forgotten but I...

It would be hard to say unless we knew what was taken of for the rebuild. Usually you would have to put back the starter, the flywheel, the balancer on the crank, the oil pump, the carbs, the rave valves, etc.. I just took mine out the piston rod Bering shredded and all the pins ended up on the...

45 is a little low. Just to give you an idea I have a 2001 xp I can hit high 60s almost 70 it’s bored .5 over. I would rebuild the carbs. Put the right plugs and tune the carb. I know mine is a 951 but a 720 you should hit mid to high 50s just my two cents

Awesome thanks for the tip

Awesome thanks guys. I am keeping it . With your help mikidymac its running awesome like a beast. Took it out today after all the stuff with the carb rebuild. Sbt garbage cable I had to send back and all the tuning stuff. Still breaking it in but man I hit 55mph easy on this thing and it can...

2001 xp looking to change my traction mats. Does anyone know of any new coupon code for a discount ? Just got done rebuilding money is tight. I know the old code being hydro15 but it does work. Hydro turf is what I am looking for but the blackfish one would work also anything better than the old...

I had a similar issue with my xp 951. Rebuilt the carbs and took it out couldnt get it tonidle right. It would rev out. After pulling the carbs out I noticed that the screws on the carbs where loose. They where getting air in. After I tightened all the screws and put it all back together it...

Perfect thanks

Just finished one I bought for 400 bucks. Had to do bottom end $699 had to machine cylinders $125 plus all other things I have close to $1,400 all in. Mikidymac is right it can spiral out of control fast make sure you do your due diligence on it. All fixed and in perfect shape you probably can...