Recent content by islandia-duane

Damaged Engine, hole in block. Mercury 240EFI, See photos. Needs repair. Other than that, electronics work, lights and audio with JBL marine subwoofer, Dual battery system, starter and house battery. Hydro Turf Floor. Body and upholstery in good shape. Shorelander trailer and Cover included...

Yep! I'm posting it for sale as is with the engine damage on the social sites. Will figure out a reasonable price since the replacement may be around 4k+

Not sure what the assemble is called. Pictures attached. The bracket that holds the Throttle cable in place and moves the lever back and forth. Broke on a routine cruise last night. It looks like it has screws so I'm hoping its a simple removal and replacement. No oil or fuel in the bilge so I...

Steering wheel: https://www.amazon.com/dp/B08MMPL34K?ref=ppx_pop_mob_ap_share Rocker switch covers: switch covers The seats were taken to a local upholstery shop.

My 2000 Islandia redone...Lake Wylie, SC. I didn't take photos of the removal/reinstall, but can advise if needed. Also changed out the steering wheel & rocker switches for ones with icons.

Mine broke just like yours and I epoxy'd and has been holding on since. I would like a replacement as well. I looked around but couldn't identify a replacement

The Stator fins look like mine..LOL

Thanks. I've been reading and you're right. I think all these parts are original from year 2000 so I might as well change out everything. THANKS!

Hey everyone! Just changing my steering cable and pulled off pump assembly and noticed it filled with milky water in the cone. I think its missing a gasket or rubber washer or something. What's missing? What's it called? Any idea of a part number?

Hey everyone! Just changing my steering cable and pulled off pump assembly and noticed it filled with milky water in the cone. I think its missing a gasket or rubber washer or something. What's missing? What's it called? Any idea of a part number? Thanks

I started looking at other issues... since it sounds like the kill switch is disengaged, cranks and cranks and cranks. I'm now inspecting these 2 units. One (REV Limiter) houses a black + yellow wire which I read is part of the kill switch circuit. Is there a way to test? Reading other...

I’ll check harness. The boat had been on the lift from the last outing a week before. Then this happened. Will restart the checks from the top again once I put the ECU back in.

Reporting back...had the ECU tested.. functioned without faults or errors. They ran that baby couple times. They said they would have loved to sell me a new box but the results show otherwise... Any other suggestions?

I’m driving up to Brucato for ECU testing will report back with results. Brucato Power | Mercury ECU Testing and Replacement

Well that will suck. The boat was home and was just sitting until the next outing. I'm hoping it's something else I could identify