So this weekend I installed a NOCO on board battery charger it’s waterproof and does a great job charging AGM batteries.
This was partly because I found both of my prior battery chargers had shot the $hit. I didn’t know that they were were not working because the indicator lights showed to be...
So last week I decided to clean up the engine bay and decided I needed to get the black moldy looking grime out of there. As I hand washed to bottom of the engine bay I bumped the black sound damping material which disintegrated. It literally turned to black dusty material. I looked at several...
The fuse box was already in its place, I used a small piece of thick rubber then I epoxied it to the bracket and let it dry. After that I epoxied it to the fiber glass. I used several tubes of epoxy to bond it to the point I didn’t think that it would move.
The set up is nice, somethings that bother me is that those tower speakers (that are running off the two channel amp) are heavy and the wake tower needs some stiffing. When in motion the tower wants to sway side to side (even when all bolts are tight). It concerns me so much that I don’t trailer...
I run three optima D34M CCA 750. Two for my audio/ accessories needs and one for for starting/ running the boat. Don’t know if this is answers your question. If you needing know anything else let me know.
P.S. they are great but looking forward I’m probably going to change them out for two...
I cleaned the ends very well with acetone then let it dry. I used Gorilla Glue and placed in a vise until it cured.
I had it back in my boat for about a month with no issues. However if it fails I'll update this post. Fingers crossed[emoji13]