Recent content by Hewett85

10-4 I will thanks I’ll let u know what happens

Oh ok good to know thanks well guess I’ll run her for a few tanks and see what happens I’m prob just paranoid but I got lots of hrs tied up in this thing I’d hate for it to crap out

Why would I block it of it’s very helpful on start up didn’t have to hook my primer up thanks to it or does it do more than help at start up also maybe this is important maybe not but I built this engine 1 mm over so I’m a atv mechanic very diff with these machines but with my ATVs need bigger...

Yes as far as I know it’s a brand new carb for gs and other 720 motors cause they quit making gsi carb there junk there they same except the new one has the accelerator pump but I might need to fine tune low screw maybe

Tune and go is how it’s been

Yeah there hooked up!! This carb is for a gs they don’t make gsi carbs no more so tube and go I’d how it’s been

What u mean doesnt have trim? Vts? Yes they do

It’s a brand new carb

It’s still hesitating at take off well when I pin it from dead stop it kind of Boggs then it’s gone what y’all think my next move should be?? On a different note tell y’all what other issues happened found that motor mounts broke so I pulled motor to also check where I had a little oil leak...

Went out today thing runs great besides a slight hesitation at take off but I’m guessing because it’s got so much oil between pump and mix in tank but I pulled plugs when I got home and there black and wet so thinking of draining tank but also noticed vibration when putting on trailer come to...

I still running 50:1 in tank with oil injection so I’m waiting to do that test when it’s got straight gas in it plug is really brown right now but I’ve got new plugs for next tank of gas thanks

Mine had same issue I replaced relay and start stop button now it works great

Thanks to all I just got back from river and that thing is off the chain fast great throttle response so gsi old carbs are trash and tested compression hot motor 140 both cylinders good enough!! Now I need to figure out why it blew the first time it only had 36 hrs from factory and it blew I put...

I know I’m hoping it levels out but with carb prob it has not. Been broke in right but just did it when I got home on cold motor and they were even 150 I used two diff testers also

Thanks man I appreciate your input so far it’s sounds great and does not flood no more still got to water test but so far so good!! Does your motor kind of sound like there knocking I’m new to skis but been at a for life it could just be me listening to hard lol I just rebuilt 1 mm over and to...