Recent content by Gordo

I have an intake grate that I bought from a dealer for my 2010 speedster that I never installed. I think I paid about $120 canadian. Where are you located ?

Good to know as I too have the Speedster. I would like to see some details of your second bilge pump when you get around to it, sounds like a great idea and a nice project.

If the neutral switch is bypassed don't you still have an issue in that the boat can be started in forward or reverse. Be careful.

I don't add any additional anti freeze. However my boat in an attached garage that will rarely get cold enough to freeze water. I do blow out the water from the exhaust system with compressed air.

There are many posts about storing your boat for the winter. I suggest you read some of these and if you have specific questions , go ahead and ask. I live in Ontario and store my 4 tec each winter. Given the extreme cold it is important to get the water out of the exhaust system as it will...

The wear ring I recently installed had a beveled edge on both ends. It can be installed in either direction.

That makes sense, thanks, I will double check , it could be I only get the sensor error while on land. I also get the four beeps when the engine has not been started yet.

Thanks, I do have the shop manual but did not help me much on this topic.

I don't really follow all this but I can tell you that I recently changed my wear ring on my 2010 NA Speedster with 155 HP the part I ordered and receive from the dealer was 267000419. The wear ring fit after cooling in the freezer and then some effort with a block of wood and a hammer. The...

I am considering buying a Candoo, but why the four beeps, maybe that is a clue to the Sensor problem ? Anybody know why a 2010 Speedster would beep four times ? I notice that the depth finder sometimes jumps around in terms of depth readings but I also have an in hull fish finder that gives me...

I would like to purchase a Candoo Pro, my 2010 Speedster has a Maintenance message that I would like to clear and I also have a Sensor message that I would like to identify. I just can't justify paying $400 US for the tool. However if we could get a few of us to chip in and we are all in the...

2010 Speedster 155 HP, 133 hrs. When I put the key on the DESS I get one long beep then screen shows MAINT then SENSOR then I get four short beeps. I recently ingested some rocks/pebbles and rebuilt the pump, maybe at that time a sensor got damaged ? The boat is running well, even faster than...

When I bought my printer two years ago, I did not research that model. I like the fact that your printer has the extruder as part of the print head, that allows you to extrude at faster rates . Good luck with your printing.

I believe the design has changed slightly for the newer 4 tec boats. I recently replaced the impeller and wear ring on a 2010 155 hp speedster and also was puzzled as to what was going on here. The piece is essentially build into the pump housing. The interface of two small holes did not even...

I have used TPU to make parts for a custom pinball machine. I find it is fairly durable. My biggest issue with TPU is that I need to print at a very low speed otherwise my extruder jams up. I use a CR10S. What printer are you using.