Recent content by fleiss75

Does anyone fix these?Has anyone tried? Any for sale? Thank you in advance!

https://youtube.com/shorts/Q0WjZCoCHEs?feature=share

Sea Doo GTX, 4tec 2005..85 hours. Has been sitting for months, new plugs, oil change, oil filter and fresh fuel..Making a strange knocking noise at idle in a little higher… Any ideas? I don’t have any errors or codes.. It reaches speeds at 35 miles an hour and the knocking noise goes away, but...

Ski fires up running problem.. going from forward to reverse it gets stuck and will not switch back until I shut the ski off. No Issues with cable.. works perfectly with ski off.. seems like an idle issue? Any one have this issue?

Has anyone ever folded the tower?

They installed a junky Dual...I was thinking the M508..plug looks the same

Hey there! Just bought a 2006 Sea Doo Speedster 200 Wake 430 Boat..looking at the stereo and amp..I know the stereo isn’t factory..I cannot get the remote to work..in the glove box is a black wire with pins..I’m assuming that’s for the remote..so I’m looking for some pictures of the original...

Yes, tried that one last time out and same result.

Same problem.. Boat starts, runs, the minute I shut it off.. Won't start. I have had every boat mechanic under the sun.. Injectors, port temp sensor, fuel pump, battery.. Same issue. New mechanic came out.. 25 year Mercury guy.. Says this part is bad and wired around it... .. I just get a bad...

Mercury mechanic came out today and said its the idler box? Sound fishy?

The OLD efi.. do you mean the sensors for 150-200 hp? would those work?

Hello Getting the boat ready for summer and I want a new battery. Does anyone have any recommendations on a great battery for this? Thank you

Does anyone know where to just buy the paddle wheel? Anyone replaced this yet? SeaDoo OEM Paddle Wheel Kit 296000193, that is the part number that I have found, but no one including the local sea doo dealer can tell me if that will fit. They only want to sell me the entire component. Any...

I installed that with heat sink and it didnt change anything...so I finally broke down and found a certified Mercury tech, he said the o rings on the injectors were leaking causing too much fuel. Once he got them to his shop, he said all injectors were clogged, soaked for a week and still...

I took a look at the oil pump and I have 3 lines on the arm... Which should it be lined up with?