Wit
With the tps installed but unplugged it runs ok normal idle rpm but with plugged in it wants to go up to 4000rpm and the throttle appears to be closed! Is the tps that “finicky” that i dont have it set right? Or is the high rpm even a symptom
I made up a set of wires to connect in between the tps and the harness and poked those wires with my dc voltmeter. When hooked up the rpm goes all the way up to 4000rpm and when unhooked the motor actually runs ok and idles around where it should
Help!!!!!! Just installed a new tps in my 01 merc 240 challenger. Cant get the proper voltages on it like my old one and when i go to start the boat it screams the rpm! What am i doing wrong
I did try adjusting it and couldnt get it to stay at .20 that they want at idle. Would randomly jump around and jump back up and wot was 3.45v or so. Im not too sure how to check the oil pump adjustment to be honest
Ive about had enough of the low end rpm smoke on my boat (enough that i smoke the marina out) ive tried changing the port side temp sender with no luck. Moving onto TPS. Is there a special way to install? How do i set it up properly. And any other ideas why im getting so much smoke bottom end...
Still having trouble with my smokey merc 240....replaced port side temp sender with no results, boat has a full tank of fresh fuel now with no leftover stabilizer. When going full throttle from a dead stop it pours white grey smoke and smokes blue when idling down a river. Please help! Uses more...
Hey everyone i recently acquired an 06 challenger with the 215 4tec. The motor needed 2 new oil pumps and a supercharger rebuild. Going back together now is there any threads about engine install and hooking everything back up? I bought it with the motor out. Looking for a checklist and help to...
Hey everyone i recently picked up a 06 challenger 215 4tec with the motor removed out of it. Currently just about to finish redoing the oil pumps, going over it, etc. Was wondering if anyone had the procedure for engine install? Im close to putting it back in and would love to have a procedure...