Recent content by CRei

The three ground wires bolted to the stator cover where do they go off too? The wire came apart from the one connector , so stripped it back and felt like the wire was rusting falling apart so to speak, thinking of just running new leads but not sure where they go, also would like to test the...

No load test tried another battery then a new one still same, open hood and on plug 2 on the MPEM move harness around seems to really help, anyway of tightening the pins up ? New harness you’ll never get. Thanks

The ski will fire up if you can get it to stay awake long enough, have 3 keys for it all original, been messing with the MPEM on harness 2, think maybe the pin came loose, move harness around and hear MPEM click and fuel pump kick on

Ok thanks, have tried two good batteries going to try a new one, maybe holding full throttle shuts fuel pump off gives it that extra power ???

Put key on get two beeps, gauges light for 2 seconds then nothing, unplug put back on same thing, do this a few times it will fire and run, strange thing if move throttle to full seems to lesson the problem weird, have tried new relay, DESS post, regulator and removed ground on block cleaned and...

I replaced the check valve in fact was not even one in there, put the line on the black end which lets nothing out only breath in, is that correct ?

Leaking needle and seat? Loading it up??

No hard start, I’ll change plugs, this is the second set of carbs on here doing same thing. Do MPEM go bad on these, rear electrical box would the coil be at fault? Thanks

Ok great I’ll get to the bottom of this sooner or later, I’ll pick up some plugs? What’s your guys thought on a rectifier? Or and faulty MPEM??

Hey thanks for the response, does not die full throttle needle stays at 3500. Return to idle then take off again then back to same thing. Very rarely stalls but fires right back up. At the 3500 rpm I pull choke and stalls immediately. Batter is new full charge on it 13.5 13.8 at idle. Have to...

Well back to the drawing board, installed check valve and bypassed fuel selector res and out connected directly with lamps on line, lines seemed to have pressure fuel was spraying out. Ok so off to the water, fires right up idles good, take off get about 10-15 yards falls flat on its face won’t...

My apologies just had one of those brain farts duh. Thanks again one of those days

Ok just leave “in”from tank on valve?