Recent content by Camcass929

Just recently rebuild the top end on my seadoo as well as replaced the fuel lines and parts on the rave valves. I have only had the jetski rev up to the full 6900rpm once or twice out of the blue. It also revs to 4000rpm and jumps to 5000rpm very fast. Does anyone else have this problem...

Just recently rebuild the top end on my seadoo as well as replaced the fuel lines and parts on the rave valves. I have only had the jetski rev up to the full 6900rpm once or twice out of the blue. It also revs to 4000rpm and jumps to 5000rpm very fast. Does anyone else have this problem. Thanks...

Thanks fellow forum member. My gauge was wrong everything works great. I guess u should check the easy stuff first. Lesson learned, thanks for the help everyone.

I believe I have it connected. It’s the one from the front plate on the front carb and connects back behind both carbs to the engine.

I took off the in line, no fuel came out when I cranked it over for about 10 seconds. I pulled the res line off and fuel came out. But I tried cranking it over with the res line off and no fuel came through. Did I do something wrong or is there a problem with the sending unit in the tank?

What do you mean by leaking? The Selector or where the hoses attach?

I have recently done the top end of my Sea-Doo XP Limited. After the rebuild it ran, I took off the Carburetors because I was chasing problems, Which I later found out to be the rave valves. I have put the carburetors on and have prime the fuel system by putting fuel in the fuel water separator...