Thanks for all the suggestions. It definitely wasn't charging and the fuses were all good. Luckily I have a pair of skis so I decided to check the charging system on the other ski and it was charging appropriately. I then pulled the voltage regulator from the good ski and installed on the one...
I went outside and checked the connections and they're good.
I decided to check the battery system and was getting 12.4 volts when off and it actually dropped to 12.15 while running. Does the alternator kick on immediately or is there a delay? I ran the ski for ~45 seconds and revved it up to...
I have a pair of 2007 RXP's non-supercharged. Yesterday while riding I was getting intermittent beeping. Sometimes it would be a single short beep and sometimes a slightly longer beep. I never got any warnings on the instrument cluster, so I'm not sure what would cause it. I did notice it seemed...
I know it's late, but I wouldn't be able to sleep if I didn't figure this thing out. After removing the cone the impeller would still not spin, so I removed it and checked everything over. After toying with it for a while I got it to spin again and gently installed the cone to make sure it...
Now that I've looked even further, it is pressed in. I was going by the online parts diagram and was thrown off. Is there a bushing or something that goes on before the impeller? If not any ideas why it doesn't spin after tightening.
-Brandon
For some reason it won't let me edit my post.
After further review I am pretty sure the part missing is SKU: 293200025
Double Lip Seal. I've looked everywhere thinking it fell off and rolled under my work bench or something else in the garage, but I can't find it. Am I looking at the right...
OK, I finally got the impeller off and the wear ring changed out. Now the problem I am having is when I put the impeller back on I have no back and forth play and it will not spin. Is there a washer or 0-ring that is supposed to go on behind the impeller?
-Brandon
I finally found the impeller removal tool, but now I can't get the thing to budge. First I tried a large breaker bar I have, next was the impact. I have even put some penetrating oil then tried again later with no luck. As a last resort I heated the inside up slightly to hopefully free any...
I have a trip planned for next week and after my last trip out I realized I need to replace my wear ring. I have all the parts to do it except for the impeller removal tool. Now I don't really have time to order it with the Holiday weekend, and it will be Tuesday before can even try to find a...
I recently purchased a 2003 Sportster LE and know very little about it. The first few times I took it out it ran great, however this last time it took forever to get on plane and failed to ever reach top speed. When looking at the impeller from under the boat I noticed that the black ring around...
I am a newbie to the jet boat world and looking forward to learning a little more by browsing the forums. I recently purchased a 2003 Seadoo Sportster LE and have enjoyed it thus far, however I'm having a few issues that I am sure will be solved in short order now that I have found this forum...