Recent content by brandingo_t

Will do, I have some resources for that. I guess because the car block I rebuilt was fully machined I did not get involved in that stage of the process.

Thank you for the tips, I'll do some investigating into the service manual before diving in. I'm almost positive I have got lucky and there is no scoring on the cylinder walls, they look pretty good from what I have seen. I was going to hone and re install, do you know the tolerances (or is...

Is there a list, or thread with all required components for a top and bottom end rebuild? Parts, seals, gaskets etc. I'd like to compile a list of everything I need for pricing and to save multiple trips/orders. Carb rebuild and fuel lines have already been done and I will be doing the carbon...

I'm in Keswick to be specific... Yeah, I was looking into ORPS, had a bit of a bad experience with them recently but theyre local and prices are fair... Thanks for the tips on this stuff!

an hour north of Toronto

Doesnt look like it was split before. thanks for the tips on taking it out of the hull

I do not know the hours

edited post, 99 SPX, so 800

Well, after my 99 SPX stalling out on me on the water I dreaded what may be the cause... I have since rebuilt the carbs, replaced the fuel lines, replaced the starter and replaced the starter relay along with charged my battery only to find out the front cyl has low compression of about 60psi...

a friend with the same machine had the same conditions, took it in to have the carbs rebuilt and all fuel lines replaced.

Thank you I guess I’ll grab 20’of both

Approximately how much fuel hose is required to replace the grey factory hose on a 99spx. On my way to pick some up now and forgot to measure. Thanks!!

Thanks! I had a look last night, going to get the kits today and begin tear down... more toys.. more money...

Thank you

Yes, I'm going to hook it up to a trickle charger and yes, I'm looking into getting the fuel line before getting it on the water again. Do I need to get anything gasket wise to disassemble what I need to in order to have a for any gummed up areas? Thanks for your help!