Recent content by Baldy63

  1. Baldy63

    1994 GTX650 winter project

    So the GTX pop off Specs Says 22 to 29 Do they run better at the lower or higher popoff. Mikuni pop off specs say a 115 gram spring is suppost to pop off at 32 lbs with the 2.0 needle andseat or does the 95 gram do the job at supposedly 25 lbs or the 80 gram which is only 21lbs
  2. Baldy63

    1994 GTX650 winter project

    Many sites say 159 degree for all 650 engines. When i took mine apart the rotary disc is a 147 degree. Did the. Previous owner just just put a 147disc in for the heck Or do some 650 engine use the 147. Degree disc. ANYONE KNOW 1994 GTX 650
  3. Baldy63

    1994 gtx 650 I am looking for oil Banjo check valve

    Partzill Okcheck valve still leaking after cheaning Found seadoo part number. 290956010. Partzilla. Sale. 11.50 US i guess i ll order a couple
  4. Baldy63

    1994 GTX650 winter project

    Question so on ignition timing ? so when i remove the stator to change the crank there is no way to double check the timing You just line up the stator with the little mark on the housing and hope for the best. If you do the static timing you have to rev the rebuilt engine to 6000 rpm...
  5. Baldy63

    1994 gtx 650 I am looking for oil Banjo check valve

    I have the engine on work bench just fininish rebuild as i did a low pressure test on bottom. I noticed the 9 lbs of pressure pushing oil out of oil lines toward the pump after 10 monutes pressur was only down to 8 so it pasted.test I noticed after i disconnected hose pressure tester . I...
  6. Baldy63

    1994 GTX650 winter project

    Thanks for info
  7. Baldy63

    i am looking for engine alignment tool for old 1994 gtx 650

    I am close to Winnipeg mb, any one have an old 140 mm, pump and shaft style or the other type they might want to sell OR maybe know of a wholesaler close to order something
  8. Baldy63

    where can i find a new or used engine alignment bar and pump style or other , close to...

    where can i find a new or used engine alignment bar and pump style or other , close to Winnipeg mb. any shops out here or someone have an old one they d like to part with
  9. Baldy63

    1994 GTX650 winter project

    Rotary timing question. Is the timing disc wear that crittical i did the test with rosin core solder with the disc inside and and they came out squished to upper .015. And lower .013 Specs say .012 + - .002 So if i add the 2 together. Divide by 2 its ok. What i am curious about...
Back
Top