Recent content by 951comet

2008 SeaDoo Challenger 230 - 23’ 6" 310HP NA Serviced and ready for the summer! Kara trailer included. 50 original hours on Engine / Hull Only used for day outings and always trailered and rinsed after use Always stored in covered heated garage Interior vinyl is in like new condition with no...

I froze the pump in the freezer for 2 hours then heat the metal case with a torch and the white sleeve popped right out by hand. No such luck with the new blue rings. I suspect these blue ones will need to be cut out when its time to swap them out given how difficult they were to press in. Not...

If you purchased an OEM wear ring they have been updated to a blue color. Part number: 267000419. I couldn't get the new ring pressed in, even after putting it in the freezer. On a recommendation from the Sea-doo tech he told me the factory recommends you grind down with a Dremel a 1/4" of...

Just finished it up. The part number to the removal tool is: 529035820. It worked perfectly.

Thank you! That helps, I guess they aren't used on the Challenger.

Hi guys, I'm changing out the wear ring on my port side pump and while inspecting the bailer passages I noticed there are what appear to be stopper plugs installed into the bailer passage between the hull and the pump. Should these be there? (see attached photo) The shop manual makes no...