Results 1 to 1 of 1
Thread: Bailer (jet-pump)
☑ ORIGINAL POSTER 09-26-11, 07:52 PM #1
- Join Date
- Feb 2009
- TampaBay, Florida
- Sea Doo 95, XP, SPX, GTX, SPI, XP, 97 Polaris Hurricane
- Thumbs Up
- Received: 36 Given: 3
The bailer systems suction box's are held to the floor by two stainless spring holders. The two lines have a 90* fitting where they are zip-tied under rear seat compartment, then go back down to attach to the two smaller of three (3rd is water pressure inlet line) nipples from the jet-pump. The venturi houseing has veins that lead out of ventiri rear where two bailer tubes are inserted, and protrude into the outgoing jet wash, that provides a constant bilge suctioning thru this system of tubes and its bailer box. If the zip-tied lines fall or the tubes break or fall out the system fails and water can ENTER into the bilge, your ski could sink!
Seadoo 140MM jet-pump venturi bailer tubes - dual taper
Newer style tubes '96-up white/clear Pt #271000464 lenghth 3 1/8" 80MM
Old School style tubes '88-'95 black Pt # 293700017 lenghth 1 7/8" 48MM
Jet pump bailer screw-in fittings are Pt # 393700017
I get these from RIVA. Briand@rivamotorsports.com
This is just information.............no Q ......please.
Last edited by Bills86e; 09-26-11 at 09:00 PM.
09-26-11 07:52 PM # ADS
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By dpvandy01 in forum 2-Stroke SeaDoo Sport Boat ForumReplies: 3Last Post: 06-21-11, 10:55 PM
By hypersniper2010 in forum 2-Stroke Sea-Doo PWC forumReplies: 2Last Post: 09-06-10, 05:59 PM
By gjkovach in forum 2-Stroke Sea-Doo PWC forumReplies: 3Last Post: 07-08-10, 10:40 AM
By mshelton911 in forum 2-Stroke Sea-Doo PWC forumReplies: 1Last Post: 08-30-09, 08:35 PM