Search results

I would like to purchase a Candoo Pro, my 2010 Speedster has a Maintenance message that I would like to clear and I also have a Sensor message that I would like to identify. I just can't justify paying $400 US for the tool. However if we could get a few of us to chip in and we are all in the...

2010 Speedster 155 HP, 133 hrs. When I put the key on the DESS I get one long beep then screen shows MAINT then SENSOR then I get four short beeps. I recently ingested some rocks/pebbles and rebuilt the pump, maybe at that time a sensor got damaged ? The boat is running well, even faster than...

I bought a new wear ring and new impeller for my 2010 Speedster as I had damaged the original hardware by sucking up rocks. Odd thing though , when I dry fit the impeller inside the wear ring with just those two parts sitting on a table, I measure a gap of 1.4 mm, really 2.8 mm at extreme but...

Went up a creek at idle speed and all of a sudden the depth went from 3 feet to 1 foot. Sucked up many rocks and pebbles. After swimming under the boat and removing the stuck rocks , I have a loss of power at WOT and acceleration is slower, plus some unwanted vibrations, higher revs needed to...

First time trying to use the OEM anti pooling poles with the 150 speedster, does anyone have a picture or diagram as to the correct location of the poles. I got it to work but am sure it is not as stable as it should be. I did look through this forum and the poppy site (they make covers) and...

Seems that the float in the tank is still at a high level with a half tank of fuel , once I go below 1/2 a tank then the gauge starts reading less than full. Anyone else have this poor calibration of the fuel gauge reading to actual level of fuel in the tank. Seems like just a poor design by BRP...

I would like to add a fish finder to my 2010 speedster. Any recommendations would be appreciated. I realize that I should mount the transmitter to the outside of the boat for best results. Anyone have experience with this, what fish finder would be recommended (willing to spend about $400) and...

I am posting this for those that do their own engine winterizing and find it is a pain to hold the mechanical throttle to WOT when it is time to fog the engine. That was exactly my scenario this weekend, my 2010 Speedster is tucked into the corner of my garage and getting access to the...

I am preparing to winterize my 2010 speedster 150 with the non SC , a 155 4 tec . I see in the manual that they suggest using shop air to get the water out of the exhaust system. I wonder how is it that when flushing the exhaust with a hose and water the engine needs to be running but when...

I have been searching for an answer but it is not clear if the locktite 518 item 32 on pump assembly with sender unit is added just to the studs or also on the rubber gasket. I have a new sender unit and gasket to install on a 2010 speedster 150 and I would think that the rubber gasket will seal...

I am a first time boat buyer and am seriously considering buying a 2010 Speedster with the 155 Hp engine and less than 100 hrs on the clock. I looked at it in the sellers driveway and everything looked good, except there were noticeable gas fumes when opening up the floor storage location. The...