Search results

I would keep the oil injection and just replace the line and bleed it.

The hull is scrap.

I would get a new tank, my 1997 leaked at the seam I found a 96 that does not have a seam pretty easily on eBay.

Idle speed out of the water is 3000 rpm in the water it’s 1500 rpm.

I ran mine on the hose only for couple of minutes just checking for leaks and to make sure the engine sounded good after that went to the water and started the break in, no pre mix on the injected skis, you can prime and bleed the oil pump with a drill, never tried to run it without the drive...

Yeah the book calls for loctite 518 I think but there are plenty of threads on here that recommend the 3 bond. I think the you tube channel Today We Wrench puts loctite the book calls for on the seals it probably doesn’t hurt anything,they seem to build some nice ski’s.

I just did the case half’s with 3 bond 1211

Not familiar with the 951 in the GTX hull, I think if you take that first section of the exhaust off there might be enough room to get to the oil lines. The 96 tanks don’t have the seem you can usually find them on eBay I have same issue with my tank on my 97 just haven’t gotten around to...

After disconnecting the oil lines will it go out the front of the ski?

I would be worried about rust staring on the crank and rod bearings. How did the counter balance oil look?

LOL,man that is way too cold for me and I grew up in the north east.

Thanks, wish the weather was a little warmer down here so I could take it out.

Thanks!!

I picked this ski up in late summer of 2021 as a winter project. I always wanted a GTX after working on someone's 99 RFI i always thought they rode real nice. The ski only had 48 hours on it and had last seen the water in 2012 and was sitting in his garage under the original Seadoo cover with...

I would have been fine if he just refunded my money and returned my cylinders.

I sent my cylinders for my 787 to them in September of 2021 and pre paid for a top end kit and bore. Communication was spotty then nothing now there website doesn’t work. So that money and my parts are gone. I got a whole top end off of River Rat Bob on eBay I’ve got 8 hours on it so far so...