Search results

Sorry for the long delay but finally got around to getting the correct parts and pulling the engine and getting an oil sample tested. Oil sample came back with only really slightly high aluminum levels, which is good, and what I expected to see. as you can see from the close-up. the oil still...

OK great! Thanks for backing up what i thought (and was hoping for). I already have a new to me supercharger, S/C rebuild kit and oil change kit. Looking for a PTO cover now. The supercharger that blew up was one that i rebuilt with SS washers so hopefully that shouldn't be an issue. As for...

Oh right, forgot to take pictures of that side. everything looks intact, but the pinion gear does look discolored slightly. Im wondering if it got hot when the bearing went? My garage will be finished in the next week or so, so im going to hold off on pulling the motor at the moment until i...

Sorry for the late response. Supercharger blew two days before we went on vacation. Got back and pulled the S/C. it definitely appears to have a failed bearing and warbled the wheel into the housing. when pulling it i noticed that the top bolt was slightly loose and figured out why once...

I just had my 2008 RXT 215 with 200hrs out on the bay this weekend. heard some grumbling coming from the back end while out on the bay. Took the seats off and tried to listen. still seemed to run fine, power as normal still could go full speed. So i originally thought it was a bad jet pump...

I have a 2008 RXT 215 that will do 65 as long as it stays hooked up. but thats what the dash says, never verified it to GPS. 8140RPM seems about right.

Yep on GWL all the time with the skis, usually launch at Murphys' Cove.

I would recommend boatdecals.biz. You can design your own name/rego numbers and apply them yourself. Very easy to do with their instructions. Otherwise I am up in West Milford and would be willing to do it for you.... just a bit far.

Do you still have the gauge cluster? Also, what is the difference between the MPEM and the ECU/ECM?

Looks like that chunk of metal is just holding up the chain tensioner. this is a terrible picture, but hopefully it helps if you zoom in to that area. I would be worried that its no longer supporting that chain properly. May be better to just do an SBT shortblock. I have had good experience...

I have an 08 RXT and am weary of the charging system, so installed a secondary volt meter that just reads battery voltage. basically at any speed after about 2 minutes of engine running the battery is at least 14v. This article from Partzilla is what i used to diagnose when i had a bad...

Perfect! Thanks for the info. That page you posted for the troubleshooting was what i was looking for, i guess i missed it the first 3 times i looked through the manual. I did the continuity checks last night and it fail one wire with a inconsistent reading + high resistance. I assume this is...

@Seadoojim1 does your ski have the 3 or 4 pin DESS post? I seem to be having the same or similar issues to you. Once you replaced the DESS post, you were able to pop the key on and it woke the ski up no problem? I tried jumping the relay and the ski powers up/wakes up, but then will only...

@mateo12344 Did you get anywhere with this? I seem to be having a similar problem.