Search results

If your replacing the impeller, you might as well replace the wear ring and kill 2 birds with one stone to eliminate any other potential issues aside from the pump itself :)

Replacing the impeller did the job, thanks for this feedback! :)

Yea, I was hoping to create a 1 stop shop for people with similar issues since I read a bunch about it. Thanks for the compliment and let me know if I need to update the original post to share more information upfront! :)

Thats just a light scrape, from installing and removing the impeller. I ran my finger over it and its not a gouge, just the lighting I guess haha.

2018 GTX 155 (75Hrs) - New Battery - New Wear Ring - New Spark Plugs (NGK 4339 - DCPR8E) - New BRP Oil & Filter (ran 30 sec, off 30 sec, little over halfway on the dip stick) - New Key Programed - I had the only key(Green Learner) programed to be the normal key (says "normal key" at startup now)...

Hey all, replaced the battery just for safe measure even though the old one load tested good. Took it out on the lake for the first time today and everything went really well! No low voltage warning! However, I did notice some oil that might be leaking from the PTO area where the drive shaft...

Okay, so I checked the continuity of all 8 grounds that I found. 3 on the FWD part of the block, 3 on top of the block, 1 below the block by the starter (main negative cable) and the one that connects from the wiring harness on the fwd side of the battery to the negative terminal plate. No...

The ski is from Arizona and has never been in Salt water from what I was told. But the light corrosion on the pump makes me think otherwise. I'll check all the ground continuity later today and look for corrosion and report back. From my initial check the other day, no corrosion exists in the...

Just purchased a 2018 Seadoo GTX 155 - 70 Hrs Upon hose testing the low voltage displayed on dash. Put it on the trickle charger all night and the next day I took the battery to get load tested, Orielly's Auto Parts, they said it tested good. Put it back in the ski, pressed the start button to...