Search results

The large exterior molded fiberglass engine hood is coming apart at the seam. I'm not sure what the gray material is but it has half way separated. It has fiberglass fibers in it but it don't look like epoxy. I guess I'm going to use marine tex to glue it back. It has cracked about half way...

After using my 2007 Speedster single engine all day I had about (I measured it) 3 quarts of water in the bilge. I noticed the water after I put the boat on the trailer. My automatic bilge float does not work and I did not turn it on that day. I did not remove the plugs until I sucked the water...

I have a 2007 Speedster 150 with what the display says as 15 hours on it.. Got it last year right before it got cold and took it out once and seemed to run fine. Got up on a plane, did not leak water, went to 7000 RPM's. Stated reading here, so I winterized it and looked at the wear ring and...

I changed the wear ring on my 2007 non SC Speedster the manual says to use anti-seize for the impeller to shaft threads. I read a lot here and everyone seems to say red loctite is the proper chemical to use. What should I use? Also, is the loctite 2 part marine epoxy the same as Marine Tex? Thanks.